Traditional Fish & Chips
Crispy on the outside, moist on the inside. Classic fish and chips are always best homemade. The real secret to this recipe is using a fresh, quality piece of flaky white fish, such as cod or haddock.
Prep Time15 minutes mins
Cook Time15 minutes mins
Course: Main Course
Cuisine: British
Servings: 4 people
- 3 pounds Russet potatoes about 4 large potatoes.
- 3 quarts canola oil for frying plus 1/4 additional cup
- 3 cups all-purpose flour
- 1 cup cornstarch
- ½ teaspoon cayenne pepper
- ½ teaspoon paprika
- 1/4 teaspoon ground black pepper
- 3 tsp Diamond kosher salt
- 2 teaspoon baking powder
- 1 ½ - 2 pounds 1-inch-thick cod fillet or other thick white fish, such as hake or haddock cut into approximately 3-ounce pieces. (Thoroughly dry fish with paper towels)
- up to 3 cups beer 24 ounces, cold. (Any beer will work in this recipe, even nonalcoholic beer with the exception of dark stouts and ales.)
1. Prep the fish
Slice fish into your preferred size portions. I like smaller pieces, about 2 ounces per piece, but sometimes you need to follow the natural cuts of the filet. You want portions that are evenly sized as much as possible. Pat dry with paper towel and set aside in the refrigerator.
2. Prep the potatoes
Peel the potatoes and slice off the “top & tail” to square off the ends of the potato and discard. Cut each potatoes lengthwise into 1/2 inch fries. Add potato pieces into a water bath for about 30 minutes.
Remove from water and pat dry with paper towel.
3. Set up the dredging station
Whisk the flour, cornstarch, cayenne, paprika, pepper, and salt in a large mixing bowl.
Remove 1.5 of a cup of the flour mixture and add it to a casserole dish and set this flour & dish aside.
Go back to the flour mixture that remains in the bowl and add baking powder. Whisk to combine.
Add 1.5 cups beer to the flour mixture in the mixing bowl and stir until mixture is just combined (batter will be lumpy). Add remaining beer as needed, 1 tablespoon at a time, whisking after each addition, until batter falls from whisk in thin, steady stream and leaves faint trail across surface of batter.
5. Dredge & fry the fish
With the fries done, increase the heat of the oil to medium-high, add remaining quart of oil if necessary and heat oil to 375°F. Pro Tip: Use a Oil safe Probe to monitor and control temperature for perfect results. (Meanwhile, thoroughly dry fish with paper towels. Dredge each piece of fish in the flour mixture shaking off excess flour. Dip 1 piece of fish in batter at a time and let excess run off, shaking gently. Place battered fish back into the dish with the flour mixture and turn to coat both sides. (This is messy, but worth it!) If you are working with a partner in the kitchen you can now add each piece directly to hot oil if or, if you choose, keep pieces in single layer on baking sheet and repeat until all pieces are coated. (It’s best if you have one person frying and another dredging. However, you can certainly do it in batches if working alone, just be careful not to let it sit too long to avoid the batter sticking to the sheet pan)
Tip: As you add the fish, you will likely need to adjust the heat to keep it maintained at 375-385°F. Not adjusting your temperature to maintain oil temperature when frying is a common, and costly, mistake. The fish will not crisp up. But make it too high, and everything will burn. Use an oil safe thermometer for best results. Fry the fish, stirring occasionally, until golden brown, about 5 minutes depending on thickness. Use a kitchen spider to remove fish from hot oil and transfer fish to a sheet pan lined with a gridded cooling rack. Never walk away!
Tip: If you are unsure about the doneness, remove one piece of fish and use an instant read thermometer to test for a minimum of 145° F.
Serve hot
Serve fish & chips with traditional malt vinegar and tartar sauce.
• You can keep fish hot and crispy in a 200° F. oven for about 10 minutes if you are cooking in batches.
• This recipes makes a large amount of batter. It can be reduced by half if you choose.
• I prefer to use separate pots of oil for the fish and the chips to avoid your chips tasting, well, like fish! But its totally a personal preference and influenced by the quantity you are making.